80s/90s Steel / 531 MTB F&Fs Dawes & Marin

I have three steel MTB frames I need to part with: two Marins and one Dawes. The Marin Bear Valley was until recently my do-anything utility-ish bike, and did a great job. The Pine Mountain I've never built up, as had bought just before I saw the Bear Valley and decided to go with that instead; the same with the Dawes, as I found an old Muddy Fox which suited me better size-wise for my rebuild in the end.

--
Marin Bear Valley, 1995ish
TT CTC 21.5"
ST CTT 19"
CW ritchey logic headset and Shimano sealed BB (I think this could do with being replaced as feels pretty grumbly - odd as I installed it only 2 years ago. I don't have a tool with enough purchase to get it out but I wouldn't consider it 'stuck')
Paintwork v good. Little bit of surface rust on chainstay; not noticeable in use.
£30

--
Marin Palisades Trail, 1992ish
Tange steel - can't remember what type
TT CTC 21.5"
ST CTT 19"
comes with original ritchey logic headset, QR seat clamp and seat post
Paint mainly good but someone has touched up the rear (zolatone) stays with plastikote or something. It's not bad and definitely good to use as is.
£25

--
Dawes Quest, 1988/89ish SOLD
Reynolds 531. This was the top of the line for Dawes at the time, I think. Check out those seem-to-be-unicrown-but-are-actually-three-piece forks!
TT CTC 21 t" / 54cm
ST CTT 19.5" / 49.5cm
C to absolute top 19.75" / 50cm
Paintwork original a bit crappy. There are a few scrapes, some surface rust and someone has touched it up with humbrol or something. Still doesn't look terrible though.
£40

--
All prices + post, which I think should be about £12 to mainland UK; payment by Paypal (+ you pay fees) or PP gift (no-one pays fees). I'm in Norwich so can post wherever, or you're welcome to come and take a look, of course.

Images are here:

MTB frames