You are reading a single comment by @deleted and its replies.
Click here to read the full conversation.
-
Good call, its basically what I've got in there, although there is a lot of grooves to allow the gas to move around, the heat sinks do a good job of gobbling heat, reducing space and limiting distortion. When all three are fitted the big holes are all covered, and then boss holes etc are just taped, therefore hopefully limiting wasted gas.
Spoke to ted today and he's suggested using thinner lines, as over 30 odd frames that should bring it down at bit (every frame having to prime them, all adds up). Pretty tedious as I've spent ages quick releasing this lot, but needs must I suppose....
1 Attachment
-
deleted
(Apols if you've already thought of this)
You could attach a solid cylinder to the bung to take up space so you have less space to fill with gas.
Also, are you using inflatable gas plugs to stop the gas escaping through the rest of the frame?