You are reading a single comment by @t0-ster and its replies.
Click here to read the full conversation.
-
IMO it's unlikely it will get to perfect indexing (on anything above 8spd) again from that point. Worth a try, but I would take it to a shop where they can use a proper tool, but there's always a chance of snappage when it's bent that far. At least you've got an EBB so can SS/hub gear if the hanger is RIP.
-
I had a bad case of mech in wheel on a steel frame a few years ago and Woodrup were able to bend the hanger back, think it was at least as bad as that. Take it to a reputable shop used to working with steel or a steel frame builder.
zooeyzooey
TM
@t0-ster
Anyone know if this gear hanger is salvageable?
more: https://www.lfgss.com/conversations/286701/?offset=175