You are reading a single comment by @TvH and its replies. Click here to read the full conversation.
  • So, two weeks in and other than some weird wheel/light niggles that are no fault of Matt's, this is everything I had hoped it would be and more. For those that care, here's a build list:

    Talbot Frameworks TIG 853/MAX Frame.
    Parlee Gravel Flat Mount Fork
    Fizik R1 Alloy Stem
    Fizik R3 Alloy Chameleon Bars
    Fizik R3 Alloy Seatpost
    Hope Seat Post Clamp
    Brooks C15 Carved
    32h HED Belgium+ Disc Rims
    Front 32h Schmidt SON Delux 12 Thru Axle CentreLock Dynamo Hub
    Rear 32h CentreLock Hope Pro 4
    Shimano ST-R785 Shifters
    Shimano BR-RS805 Flat Mount Calipers
    Shimano SM-RT99 Rotors
    Shimano 6870 derailleurs
    Shimano 6800 Cranks/Chain/Cassette
    Shimano 105 Pedals
    PDW Black City Mudguards
    Schmidt SON Edelux II Light Black
    Schmidt SON Rear Light Black/Clear

    Only thing I may change is the handlebars, purely on a fit basis. The fit data @scherrit drew up for me was with bars that were 10mm shorter in reach than these, so it is perhaps a tiny bit longer than I'd like. The length of ST-R785's is not helping matters either. Unfortunately Fizik don't make 75mm reach bars, so I may have to swap out all of the finishing kit.. cause obvs it has to all match. The bike in general is mega comfy, but also very stiff when you want it to be and is also fast.

    Thanks again @coldharbour - couldn't be better.

  • Unfortunately Fizik don't make 75mm reach bars, so I may have to swap out all of the finishing kit

    Why not just a shorter stem? Or would that look too choady?

  • So, if I get a shorter stem my knees will be too close to the tops of my bars when out of the saddle and whilst sitting on my top tube. I don't want the bars to be any closer, just the hoods themselves.

About

Avatar for TvH @TvH started