You are reading a single comment by @stevo_com and its replies. Click here to read the full conversation.
  • One of the presenters on Mountainbike Radio (on either "Just Riding Along" or "The Path"[bikeshop show]) reckoned that proper SS cogs only really work with pre-set chain tension (i.e track ends, sliding dropouts, EBB). He said that if you're using a sprung tensioner, you need teeth shaped more like cassette sprockets to avoid chain jump.

    The easiest option will probably be to get as close to a magic gear as you can, with the tensioner acting as insurance and accounting for a bit of chain wear.

  • The more I read the more I think the amount of engagement is the issue. I think I'll try the half link first as it is the cheapest and easiest.

    It only happened a couple of times on the way home and again only when setting off (and even then not every time). I couldn't replicate it when I wanted to so I'm guessing it is borderline. Even Gipsy Hill couldn't make it slip.

    However, yesterday's and today's times up GH were both 5 seconds off my Strava PR for GH considering it's been about six months since I tried it on one gear so I'm still really happy with the bike.

  • What's the freewheel and how old is it? I found my old(ish) shimano freewheel would skip what felt like a few links at a time as it got older.

  • I had the same problem you describe on a singlespeed set up with a chain tensioner. I could change the way it tensioned so setting it up to push the chain in rather than out solved the issue.

About

Avatar for stevo_com @stevo_com started