You are reading a single comment by @Scrabble and its replies.
Click here to read the full conversation.
-
There was no spacer, nothing that seemed to be impeding the passage of the axle through the BB.
The only 3 possibilities I can think of are:
- The axle on the Stylo cranks is too short - seems impossible as having a 68mm BB shell, if anything, the only issue should be is that the axle is too long.
- The axle is fucked
- The axle is as far through the BB as it is supposed to go, and it's actually the threads on the bolt on the NDS crank arm AND/OR the threads on the axle that are fucked
- The axle on the Stylo cranks is too short - seems impossible as having a 68mm BB shell, if anything, the only issue should be is that the axle is too long.
-
Except when it isn't...
NurseHolliday
hippy
@Scrabble
Did you look to see if there was a spacer on the GXP BB?
GXP is GXP. I've never had any problems that aren't spacer related.
I hope this advice does not frustrate you further and appologise in advance if it does.