You are reading a single comment by @TurtleRecall and its replies.
Click here to read the full conversation.
-
novatec d771sb
schematics at 0:29 in this video https://www.youtube.com/watch?v=iNuWQYw7e1A
There is a tube between the 2 bearings that has to be pried gently aside
(ok maybe) ala 5:00 in this video:
https://www.youtube.com/watch?v=I1E3AI9QH4E
svenhöek
@TurtleRecall
Bit of a dredge, I know...
Is there a bodger's method to remove sealed bearings on something like the novatec d771sb?
Basically it's got replaceable end caps, then a 6902 bearing on each side of a hollow centre that appears to be the same diameter as the inner bit of the bearing, so no obvious way to get purchase on it from the opposite side...
Also, no central axle to use to tap the bearing out from the opposite side, so do I need to actually buy an internal bearing puller?