You are reading a single comment by @nomoreknees and its replies.
Click here to read the full conversation.
-
Easy out is my very last resort.
I'm hoping the milliput today will work (won't know until it sets tomorrow)
nomoreknees-
Ah well. Least you wont' end up with this...
-
If you can get the pre-load bolt out - which admittedly is tough when the pinch bolt/s are torqued - you might be able to non-destructively remove the arm with a bearing puller. See Campag Power Torque Removal.
Once off, a pillar drill and tiny drill bits would be the next port of call should all else fail.
Howard
No luck with an easy out either? Dang.