Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

You are reading a single comment by @Brommers and its replies. Click here to read the full conversation.

•

Fforiwr in reply to @amey

Ha, yep have seen that. But only ever for the RH, for the LH would you just programme them differently? (Coming from no DI2 experience).

Another option was along the lines of this

http://dinosarti.com/blog/2013/5/23/hacking-the-heck-out-of-my-di2-9070

Mentioned up thread, and potentially doing both with the cat eye buttons, but fitting them under the Hylex hoods instead of the climber buttons. I think they'd be a lot neater than the climber buttons too.

•

Brommers in reply to @Fforiwr

For the front derailleur you'd need either a hydro Shimano shifter or the hacked guts of any eTube front shifter. SW-600 climbers shifters can only operate the rear mech.

•

Fforiwr in reply to @Brommers

Hmm thought as much, have seen mentions of 'just using it on the left hand side' but no rel evidence of it being done.

If I do end up going the DI2 route, then hacking the guts of r671 to shifters seems the best bet as they come for front and rear

About

Avatar for Brommers @Brommers started