Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

You are reading a single comment by @Fforiwr and its replies. Click here to read the full conversation.

•

amey in reply to @Fforiwr

You need this then:

https://www.bike-discount.de/en/buy/shimano-dura-ace-ultegra-di2-sw-r600-shift-switch-10-11-speed-right-hand-40313

https://www.trpbrakes.com/category.php?productid=1250&catid=206

https://www.youtube.com/watch?v=kiPNndG4Uh8

•

Fforiwr in reply to @amey

Ha, yep have seen that. But only ever for the RH, for the LH would you just programme them differently? (Coming from no DI2 experience).

Another option was along the lines of this

http://dinosarti.com/blog/2013/5/23/hacking-the-heck-out-of-my-di2-9070

Mentioned up thread, and potentially doing both with the cat eye buttons, but fitting them under the Hylex hoods instead of the climber buttons. I think they'd be a lot neater than the climber buttons too.

•

Brommers in reply to @Fforiwr

For the front derailleur you'd need either a hydro Shimano shifter or the hacked guts of any eTube front shifter. SW-600 climbers shifters can only operate the rear mech.

About

Avatar for Fforiwr @Fforiwr started