Anyone know anything about disc brakes?

You are reading a single comment by @edscoble and its replies. Click here to read the full conversation.

•

TvH in reply to @TurtleRecall

If you're aligning the caliper using the squeeze lever and tighten technique I've found it can often be a little off. I tend to do mine by eye.

•

edscoble in reply to @TvH

I've found it can often be a little off.

So did I, usually because the bolt often move the calipers when tightening up, which is a bit annoying.

a tiny dabs of copper slips between the washer and bolt work reasonably well.

•

Cranky in reply to @edscoble

I have the same issue with my Shimano BR-CX77. Do you mean out copper slip on the ID of the washer as opposed to its upper/lower surfaces? I'm keen to give this a shot.

About

Avatar for edscoble @edscoble started