Cannondale Aficionados / Owners

You are reading a single comment by @mcmyk and its replies. Click here to read the full conversation.

•

Currid in reply to @mcmyk

Not that one. I've got this setup: conical spacer - stem - spacer - topcap.

It's a regular spacer I've currently got but would like one with a narrower profile. All it does is allow for the top cap to compress the bearings...

•

mcmyk in reply to @Currid

Ah i see!

are you using an SI expander? if so you don't need to run a spacer on top

If not, i have this same issue on my Synapse, where the 5mm spacer is slightly wider than the top cap.

•

Currid in reply to @mcmyk

Yes but without the spacer I wasn't getting and pre-load on the bearings. It's a 2mm space, no big issue carrying on using it, I'd just like something aesthetically neater.

About

Avatar for mcmyk @mcmyk started