Any question answered...

set the levers so that the tip touches said flat surface.

Thanks, I heard that before I think, will try here...

What is the definitive answer on using an 11 spd Ultegra casette with 11 spd Campag chain and chainset (Chorus)?

It will be fine. Shimano will probably try to convince you that it will shift 2 degrees of crank rotation sooner if you use their chain.

I've been running a Shimano 11 speed cassette with a Campag set up for over a year now without any major issues. There's a mildly irritating misalignment in the middle of the block, but that could be resolved if I had the will and actually tried adjusting the cable tension. But if it ain't broke...

Me. Lots of them.

What kind of posh oven do you have?

Praxis BB for M30 cranks in BSA shells.
Upgrade SRP £35. Everywhere lists it for £50+, claiming RRP £60.
Did the product change recently or something?

Assumed M30 would be like GXP and bought a "DMR AXE M30 BSA BB" from CRC for £31. Arrived in a Praxis box with a "DMR AXE etc etc" sticker over the Praxis part info and barcode. Turns out, DMR AXE cranks has a removable driveside, like RaceFace X-type chainsets, whereas my Praxis Turn Zayante M30 cranks have a removable NDS crank, like Shimano HT2.

The bearing's the same on both sides, but there's a 2mm thick sleeve pressed into the bearing on one side. The wrong side.

Option 1: Press out sleeve from right bearing and press it into the left bearing.

Option 2: push both bearings out of their cups and swap them over.

Option 3: remove both bearings, press out the sleeve, buy shiny new bearings, press sleeve into new left bearing, fit new bearings to cups.

Option 4: return to CRC and hope they don't mind the damaged box and sticker, buy normal M30 BSA bb from somewhere else for too much money

Help?

I read that twice and still didnt understand .. I have praxis with M30 that I installed last week ..

Option 5: Buy Shimano.

You remember one side has a smaller hole than the other side because the 30mm axle steps down to 28mm?

I bought a BB that CRC said would fit, but it won't because Praxis cranks have their splines on the left side, DMR cranks have their splines on the right side.

My other non-fat bikes are almost all Shimano HT2.

All the equivalent spec Shimano cranks at this price on eBay were either worn out or lacked chainrings.

Ah yes .. option 2 if it's feasible

Option 5 machine 1mm off the axle on the opposite side and add 1mm to the other side SIMPLz

I don't like this option, it's me that has to fit it.

I'll just try harder with the hammer.

.

If I was that mad I'd just run then lefty.

can I use any sram med cage 10 spd rear mech (road or mountain) with my 10sp apex brifters?

What sort of glue do I need for inner tube patches? I'm planning on buying a decent quantity on ebay.

Best product to waterproof this bag?

https://www.mrporter.com/en-gb/mens/battenwear/day-hiker-canvas-backpack/737124?ppv=2

vulcanising fluid: http://www.tyre-equipment.co.uk/acatalog/Tin--235ml--Schrader-QUARTZ-Vulcanizing-Fluid-66315.html

Vulcanising cement/glue

^, ^^ that's the one - thanks

You recycling inner tubes to make a gimp suit?

He's repairing his current gimp suit.

I'm accessorising.

Pics