You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
fizzy.bleach
edscoble
Is there a groove to guide the cable near the hole in the shifter? On my Mirage shifters the cable wanted to stick straight out which meant the rubber hood wouldn't sit over it properly. I just pushed it down into the groove and wrapped electrical tape around a couple times. Didn't need to kink the cable to get it to sit in. This was using the Jagwire outers that have a special flexy section that goes under the bar tape.