1. Home

Current Projects chat and miscellany

You are reading a single comment by @Colonel_of_Truth and its replies. Click here to read the full conversation.
  • •

    Finally put a group on and roughly cabled my Orbit America.

    Thoughts:

    1. The gear outers rise sharply up out of the shifters. Is this normal? I have to put quite a kink in them to get them running smoothly along the bar.
    2. One BB cup does that horrible thing where once I tighten it past a certain point it clunks and goes one thread looser. I've tightened it up to the point just before it clunks, which is definitely under torque. I'm guessing the threads on either the cups or the frame are pooped, but they didn't look too bad. I might have cross-threaded it but haven't managed to do that ever before. Will Locktite be my best option for a bodge or should I give up and throw it all in a bin?
  • •

    Is there a groove to guide the cable near the hole in the shifter? On my Mirage shifters the cable wanted to stick straight out which meant the rubber hood wouldn't sit over it properly. I just pushed it down into the groove and wrapped electrical tape around a couple times. Didn't need to kink the cable to get it to sit in. This was using the Jagwire outers that have a special flexy section that goes under the bar tape.

  • •

    Yeah, and that groove makes them stick out. I'm actually using proper Campag outers. I say kink, it's just a sort of sharp bend that requires a bit of force to make the cable sit flat. It'll respond to some forceful taping, but just seemed an odd exit route.

About

Avatar for Colonel_of_Truth @Colonel_of_Truth started

About Terms of Use Privacy Policy Cookie Policy Report a problem