You are reading a single comment by @ChasnotRobert and its replies.
Click here to read the full conversation.
-
Thanks, I think I gather your two wire into a single banana, but what scares me is that there is no mention to this in the manual.
Is dual mono bi-amped configuration different from bi amplification or are these two denominations describing the same thing?
All I wanted to do (because I heard it was better) was to amplify each speaker separately, not treble and bass separately.The diagram confuses me... At the output of the power amp, it shows left and right, where in my tiny understanding of all this it should say + and - as per the connection on speakers.
veLLo
@ChasnotRobert
Bi amping requires speakers with a cross over opened up to receive separate inputs for the bass and treble drivers.
In your circumstances; either just run one channel from each amp to each speaker, or you could consider running both positive connections and both negative connections from the power amps into the appropriate connection on the each speaker, probably necessitating terminating two wires into a single banana plug at the speaker end.
Bear in mind that I'm not an electrician.