You are reading a single comment by @CYOA and its replies. Click here to read the full conversation.
  • Usually pump pliers work on those nuts, just to free them then they should turn off by (a gloved) hand.

    When you are replacing a flush mechanism it's a good idea to hoover out the water from the bottom of the cistern as the flush never gets rid of it all.

    Check if the handle is pulling the arm up far enough, you can shorten the flush mech arm by bending the top a bit more.

    Loving the bit of swimming float that's saved someone from having to replace the ball cock. Probably couldn't find a ball cock that would fit in the cistern on that arm and couldn't face the dodgy inlet valve plumbing. I'm seriously remembering that bodge for the day I might need it.

About

Avatar for CYOA @CYOA started