You are reading a single comment by @M_V and its replies. Click here to read the full conversation.
  • In that case you can probably manage with a couple of pieces of thick wall pipe, one whose id is the same as the head tube od. Cut this in half length wise and press into this using another piece of pipe of the requisite OD. Unless you are using very thick material for the badge then you may need something very robust.

  • I'm using some sort of pipe at the moment (it was left in the garage when I moved in) with old sockets to press into it but finding it surprisingly soft considering how much effort it too to cut it up. Was hoping for a more long term solution but might just have to visit b&q/homebase and see if they can offer anything that'd be an improvement.

About

Avatar for M_V @M_V started