You are reading a single comment by @hamrack and its replies. Click here to read the full conversation.
  • Has anyone got any decent pictures showing how I might neatly secure the light cables to the frame? I'm wary of cutting the wire down just yet so I have quite an excess amount that'll have to be taped to the fork.

    The rear might go through the frame but I'm yet to try that.

    How much slack do you leave at the hub? I'm guessing not much otherwise it'll end up in the spokes - guess I'll have to remember to take the connector off instead of my usual Hulk Smash hitting the front wheel out when I flat. Fuck, this dyno setup won't even last a single ride will it?

  • Enough for you to be able to fiddle the connector into place. There's no need for masses of slack. A cable tie can be useful to hold it in place if needed. I normally wrap the cables around the tubing with a cable tie either side of where it jumps the headset (to make sure it doesn't pull too tight).

About

Avatar for hamrack @hamrack started