You are reading a single comment by @negaatio and its replies.
Click here to read the full conversation.
-
I switched from fsa rings to 2nd hand praxis works and as the chain dropped on the outer side of the rings I took off the fd and wanted to set it up fresh.
It seems that setting up the L screw on the small ring - (physically) big cog configuration runs out of potential for adjustment. Not a major issue but it just rattles slightly. Might be the disc rear 135mm?
I'm also having trouble with the shift from small to big as it requires quite a lot of torque on the lever. H screw is where it is supposed to be and the fd shifts with equal efford between the rings but the force I need to employ for the small -> big -shift is quite significant and more than the fd had on factory settings. Should I try to set up the fd a bit higher?
negaatio
weird, i've just switched to 11 speed and am having real issues getting the front mech working properly, it seems that if the chainrings were a couple of mm further out it would be fine, but as is it isnt trimming properly at all because outer limit screw is so far in.