-
Have you considered getting disc tabs instead?
-
Ted could probably make the correct bosses for you. He makes pretty much everything else.
He's also got an unbelievably long waiting list these days.
-
This: http://www.framebuilding.com/Bosses.htm
Ceeway also sells paragon machine works, they are in Erith if you want to ride down and have a look and buy.plus ANY framebuilder tbh .. arent you tight with Quirk? Otherwise Winston Vaz, Matt from Talbot the list goes on.
personally I'd decide which brakes, mini V or canti and then look at the manufacturer spec for the brakes, they generally have advised distance (width) between each bosses. I'd go with Paul Minimoto, they dont need that spring hole interface.
Remember V1 is a commodity that you are fucking with. Think of the resell. Hence get a pomp as MVP.
You are reading a single comment by @Nice_Ben and its replies.
Click here to read the full conversation.
voxelwise
handtightenonly
amey
@Nice_Ben
Been in contact with ted waiting to hear back @b&d
@swedeee yeah hunting down the correct bosses is a nightmare Coz I've never used cantilever brakes before, getting a lot of feedback saying to weld a rear bridge and drill the fork for standard calipers but I don't really wana go down that route