You are reading a single comment by @seafish and its replies.
Click here to read the full conversation.
-
there's no edges it just clear plastic. So this is definitely my own fault and not the film processing shop?
seafish-
I had it a similar film on a konica, it turned out that the mechanism in the film advance lever was dodgy and was slipping under tension - it worked fine while the back was off and film loading but lacked strength to pull film out of the spool
-
Did the full length of the film wind back into the canister?
?
In other words: was rewinding over too quickly, a symptom of the film not being taken up and advancing?
Rik_Van_Looy
miro_o
If there's absolutely nothing on it yes. If the edge markings are developed properly then it probably wasn't winding on.