You are reading a single comment by @TM and its replies. Click here to read the full conversation.
  • One of the track ends are a tiny bit higher than the other causing the wheel to sit slightly off centre at the seat stays.
    I want to remove a bit material from the track end to allow the axle to sit a bit lower. Doing it on both sides could give me a welcome mm of extra tyre clearance.
    My question is what should I add over the axle to secure it down?
    See exaggerated illustration attached. Contrary to the drawing my axle already sit at the edge of the track end so I want all the support I can give it. I can't see myself welding or brazing anything in there though.
    Any suggestions welcome.

  • Just file it, will be fine, I've done it before. You're not exerting much force on the ends. Imagine trying to bend out with the grip provided by a file!? Not like you're levering it with a a pair of grips

About

Avatar for TM @TM started