You are reading a single comment by @TiBont and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@TiBont
might want to do a loading analysis for cornering which will add greater out of plane loading to the spoke flange? Furthermore have you accounted for surface finish?
You should really do a convergence plot of multiple tests to make sure the model is working and tending to an ultimate stress value. If you exploit the symmetry of the hub the simulation time will be reduced as you only have to run a fraction of the nodes.
Great thread though!
Maybe you could make an awesome personalised seat clamp too