You are reading a single comment by @MechaMorgan and its replies.
Click here to read the full conversation.
-
I was giving some though to just sanding both clamping surfaces down until they're flat and then using a shit tonne of assembly paste / torque to keep the fucker where I want it. Probably not worth it for the 0.5º change in angle I'm after.
Slightly better photos for @amey
1 Attachment
-
MechaMorgan
My saddle points ever so slightly down, the next point on the seatpost is slightly too nose up. So I was thinking of creating some sort of wedge shim to sit between the saddle rails and the lower seatpost clamp, therefore pushing the nose of the saddle up.
Edit: this is only a thought, not weighed up any cons yet. May have a tinker about in the shed this weekend.