"SONIC boom" (aka Yokel-Motion 2.0)

You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.

•

Scilly.Suffolk in reply to @gbj_tester

I should probably have done this in the first place, but I've just offered the plates up: two of them completely fill the well, from which I assume that the risers sit on, rather than in the well?

So I do need another pair which will cost me another EUR12.50 in shipping.

FFS

I've measured them again and two are just over 3mm: is a 2mm bridge adequate?

•

gbj_tester in reply to @Scilly.Suffolk

I assume that the risers sit on, rather than in the well?

Yes, because my risers have a deeper chord than the stock ones.

is a 2mm bridge adequate?

Check your thread engagement, if there's enough to use a 3mm bridge I'd stick with that. The Mk1 had one set of converter plates added without needing longer screws.

In the end, you're the one with the Mk2 bars in front of you, take measurements and see what will work.

•

Scilly.Suffolk in reply to @gbj_tester

I meant is 2mm thick enough for a bridge, aside from the question of engagement.

It sounds like you think 3mm is preferable.

About

Avatar for gbj_tester @gbj_tester started