"SONIC boom" (aka Yokel-Motion 2.0)

You are reading a single comment by @Scilly.Suffolk and its replies. Click here to read the full conversation.

•

umop3pisdn in reply to @Scilly.Suffolk

OG Ventus don't need them I think.

•

Scilly.Suffolk in reply to @umop3pisdn

... add the spacer stack, including the 2mm for the conversion plates. You might want to get the bridge made from 3mm stock to make everything add up to an integer multiple of 5.

Perhaps the mkI only need one pair of conversion plates?

~~But mkII definitely need two pairs?~~ EDIT see below

If so then we'd need 2mm bridges...

•

gbj_tester in reply to @Scilly.Suffolk

Perhaps the mkI only need one pair of conversion plates?

They do, but I think they are only 1mm thick. I've got to take it apart sometime, so I'll have a measure.

There's a certain amount of wiggle room in the stack height, the screws don't bottom out if they are the 'right' length, I suspect that 5mm increments on the screw length would allow you to have proper thread engagement but no bottoming out for the full continuum of riser stacks.

About

Avatar for Scilly.Suffolk @Scilly.Suffolk started