Current Projects chat and miscellany

You are reading a single comment by @BTR88 and its replies. Click here to read the full conversation.

•

pdlouche in reply to @JWestland

I got 14mm. Guaranteed my calishits are out by at least 0.1mm, maybe up to 0.5mm if the error is exponential, but I'm still not convinced by this BB. Not known a 'correct' axle sit so bad inside a crankset.

•

BTR88 in reply to @pdlouche

I had the same issue with this BB and remember reading on their website (they've since changed it) that they use a slightly different taper angle than ISO as suggested by @mdcc_tester. They didn't mention anything about JIS if I recall correctly so that might explain why tester's JIS spindle is fine

•

gbj_tester in reply to @BTR88

remember reading on their website (they've since changed it) that they use a slightly different taper angle than ISO as suggested by @mdcc_tester.

On whose website? I've never said anything about taper angle being different between properly made JIS and ISO spindles.

About

@BTR88 started