You are reading a single comment by @pdlouche and its replies.
Click here to read the full conversation.
-
I'll throw the shit caliper in the bin. It was in the bottom of the toolbox for a reason.
Maybe @JWestland is right, that the angle of the tape isn't the same as old ones...
So, considering that a crank sits barely 50% onto this axle, and now ignoring my shit earlier measurements, should I just mount it? Is this standard?
3 Attachments
-
pdlouche
If your axle really was 13mm minimum across flats, the crank would be pushed out about 9mm. The error on the axle width is multiplied by 28.6 (i.e. 1/tan2°) as an axial displacement of the crank.