You are reading a single comment by @umop3pisdn and its replies.
Click here to read the full conversation.
-
The tricky bit is these...
Right link? It's the same link as the first one, which is for the risers.
-
The tricky bit is these which you need 4x (2x set) to fill in the recesses in the base bar to allow you to use the spacers.
Ah.
I missed that first time around and only ordered one set (two plates).
But I'm a little puzzled now, as each plate is 1.55mm thick (so two would be 3.1mm) and not 2mm (ie 4mm for two).
@mdcc_tester suggested getting a 3mm bridge to keep the stack in 5mm increments, which indicates one plate only.
Scilly.Suffolk
@umop3pisdn
You need to email Fibrelyte requesting however many spacers made from Tester's drawings.
Bolts need to be whatever stack is + original bolt length, can't rememebr off the top of my head but it's might be 30mm.
The tricky bit is these which you need 4x (2x set) to fill in the recesses in the base bar to allow you to use the spacers.