-
Bit optimistic
-
Front
P.C.D. 62mm
F.T.F. 70mm
Offset 0.0mmRear
P.C.D. 62mm
F.T.F. 59mm
Offset 0.0mmLooks about right, the flange to flange dimensions are overall, not centreline to centreline but spoke length is not highly sensitive to small changes in that dimension.
My ones with the old pattern lock nuts are 495g for a pair with track nuts but without lock rings. Nuts are 61g for a set of four, so even if Novatec forgot to include them in their weights, they're using Italian scales; there's no way the new pattern lock nuts are 30g lighter than the old (38g per hubset) ones unless Novatec have discovered a new material with negative gravitational mass.
With cut down bolt-on axles and minimalist lock nuts, mine are down to 400g for a pair including a method of keeping them attached to the bike.
You are reading a single comment by @abr and its replies.
Click here to read the full conversation.
umop3pisdn
gbj_tester
@abr
Planning to build up some Archetypes on Novatech track hubs (A185/A186)-
http://www.eshop.novatecwheels.eu/category/hubs-non-disc/a185sbt-a-track/
http://www.eshop.novatecwheels.eu/category/hubs-non-disc/a186sbt-a-track/
Does anyone know if the measurements on the site are accurate for calculating spoke length? Otherwise will probably wait until I get them to order the spokes.
Also, are claimed weights of 172g/233g accurate?
Front
P.C.D. 62mm
F.T.F. 70mm
Offset 0.0mm
Rear
P.C.D. 62mm
F.T.F. 59mm
Offset 0.0mm