You are reading a single comment by @Scilly.Suffolk and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Scilly.Suffolk
There should be enough room to make a 1"×24TPI hole at 160mm in place of the 9/16"×20TPI at 165mm to fit some PD-7300s :-) There's a tiny bit of damage to the crests of the 1" thread on one side, it's not fatal but you can avoid it completely by going to 161mm