You are reading a single comment by @Scilly.Suffolk and its replies.
Click here to read the full conversation.
-
They're 165mm though, which are quite scarce so I won't be getting them chopped
There should be enough room to make a 1"×24TPI hole at 160mm in place of the 9/16"×20TPI at 165mm to fit some PD-7300s :-) There's a tiny bit of damage to the crests of the 1" thread on one side, it's not fatal but you can avoid it completely by going to 161mm
gbj_tester
@Scilly.Suffolk
In other news, I've just bagged a pair of 7400 cranks for a reasonable £45 shipped (from the US).
They're 165mm though, which are quite scarce so I won't be getting them chopped.
They'll do in the short term and once I have some shorter ones, they'll go on YM 1.0.