You are reading a single comment by @snottyotter and its replies. Click here to read the full conversation.
  • I dont think a 9mm thru axle (skewer) like this(?):

    is strong enough to be the main axle. You need a axle for your thru axle to go through...

  • It's not too different than the 9mm tube that's in there at the moment, but will be without the 5mm bits of standard qr at the ends. Looking at a hope pro 2 evo there is a centre tube and the end cap/reducers pass through the bearings and the tube to some degree making enough of an extra axle to run just a standard qr through with it all under tension. I will be knocking up a spacer tube for between the bearings that will hopefully be the right size to be under tension when all clamped up, but there won't be anything passing through the bearings and it in the same way as the hope. Try it and see I guess, I just wish the DMR nutted axle conversion kit actually existed, rather than being vapourware.

  • Wouldn't you be better off tapping a thread to the inside of your QR axle and using bolts instead?

  • ...hope hub... and the end cap/reducers pass through the bearings...

    This is the difference to your 9mm setup idea. You have the bearings sitting on the thru axle directly like the hope 20mm (which is stronger). But yes try it, Im interested in hearing if it works!

  • Let me know how you get on, have always wanted to do this to my Pro 2 Evo front hub, the Superstar skewer has been fine tbh but would much rather a threaded axle like the on the rear wheel...

About

Avatar for snottyotter @snottyotter started