Thanks for both the above. As there's no brake on the front of it I wouldn't be able to loosen it off against anything, however if I can get it to turn that might free it up enough to then tap out, or I suppose I just spin a brake calliper onto it. Only concern is that tapping in a torx/6mm bit might drive it even further into where it's currently stuck.
Will give some attention this evening and see how it goes, would rather avoid paying an engineer.
Thanks for both the above. As there's no brake on the front of it I wouldn't be able to loosen it off against anything, however if I can get it to turn that might free it up enough to then tap out, or I suppose I just spin a brake calliper onto it. Only concern is that tapping in a torx/6mm bit might drive it even further into where it's currently stuck.
Will give some attention this evening and see how it goes, would rather avoid paying an engineer.