You are reading a single comment by @rive_gauche and its replies.
Click here to read the full conversation.
-
causes:
tool too big for 'weight' of material it's cutting into
you're being too ham fisted and feeding in too much of the tool at each cutting pass
you've not taped the cutting side on the workpiece
the workpiece is not clamped securely enough@Airhead will be along to deliver the definitive sermon
rive_gauche
Anyone used a router table much?
I'm trying to use it to cut box joints in 18mm ply... made a lovely jig and everything.
My problem is that the bit is delaminating the ply, and also kicking the work piece around a worrying amount. I'm using a 25mm bit - is this too big to use?