You are reading a single comment by @jetski and its replies.
Click here to read the full conversation.
-
That's not what I meant. I'll try to find a photo later.
-
drøn: the clearance shall be maintained. I.e. I don't want to this to be a round tube again (it never was anyway).
No: imagine placing a tube in the cutout, at right-angles to the bridge (like a cross) so you can mark the size and shape of the lid on the tube, before you cut it out.
-
Thanks scilly.
same principle as used in this chain stay: http://lh3.ggpht.com/_FT9fLZv0mMs/S5GGlu63qtI/AAAAAAAAADc/ASJ4QkcUYTs/s800/chainstays.jpeg
drøn
Scilly.Suffolk
@jetski
drøn: the clearance shall be maintained. I.e. I don't want to this to be a round tube again (it never was anyway).
ColnagoDaft: so, there is no chance of simply filling it all up with brazing solder?