You are reading a single comment by @Dammit and its replies.
Click here to read the full conversation.
-
Screw it shut with a shim to simulate clamping distance?
#ianaengineer
Screw it shut with a shim to simulate clamping distance?
#ianaengineer
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Murphy's_Law
@Dammit
With the slot in the band I think that the lathe would just chew it up rather than boring it out.
If the band was solid then no problems, but using the TIG to en-solidate it before boring, then cutting the slot back in would FUBAR the anno finish that we are trying to preserve.