Wheelbuilding / Wheel Building / Wheel build help

You are reading a single comment by @JWestland and its replies. Click here to read the full conversation.

•

gbj_tester in reply to @mcmyk

maybe CX Rays after all?
I was only avoiding them because they're so expensive

If you think they're too expensive, don't get them. They're good, but very much a marginal gain in performance. If you were concerned about a couple of Watts at 50km.h^-1 you wouldn't be using Archetypes.

•

JWestland in reply to @gbj_tester

Now that we are talking spokes, what do you think about ACI ones?

http://www.ebay.co.uk/itm/331585906622?_trksid=p2055119.m1438.l2649&var=540739718734&ssPageName=STRK%3AMEBIDX%3AIT

Perhaps a bit silly to put bladed spokes on my 28H rims, but on the other hand, why not...

•

gbj_tester in reply to @JWestland

what do you think about ACI ones?

I've used the round ones, they're fine. At least one reputable builder thinks they're actually better then DT

About

Avatar for JWestland @JWestland started