You are reading a single comment by @Hulsroy and its replies.
Click here to read the full conversation.
-
If it doesn't fit I will hang my head in shame and buy the right one.
Although the catalogues I found say 26.4mm usually, so it's a bit of a gamble.
Anyway: there's not much room in the dropouts and I'm good at pulling rear wheels out of alignment.. Is there any recommended chain tensioner for this setup?
The Surly Hurdy Gurdy should work, but it's expensive...
Murphy's_Law
@Hulsroy
No, unfortunately you can not do that. Reaming isn't about removing material form the tube. It is more a matter of 'rounding the inside' after heat has de-shaped the tube and removing burrs.
0.2 mm doesn't sound like a lot, but it is in a tube. Get the right seat post.