You are reading a single comment by @Howard and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Howard
joel_austen
Some assistance required please:
System Six + Hollowgram SISL + SRM (mounted on Hollowgram obviously).
What combination of axle and spacers works? The original 104mm axle blatantly doesn't, the rear of the SRM hits the frame before the drive side cranks bolt is anywhere near tight. This is using FSA bearings, SI bearing covers, 3 x 0.5mm spacers, and the wavey washer. The SRM is properly fitted, the lockring flush to the rear of the cranks.
Cheers,