You are reading a single comment by @hugo7 and its replies. Click here to read the full conversation.
  • @hugo7
    i have one. they do not have a flared end. gauging the minimum insertion point is tricky without a felt marker or similar.
    they are lighter than the original brompton titanium post and clamp combination

  • Cheers. I think I might go for it.

    I was thinking if I wrapped a bit of tape around the bottom, or if I could find some way of scoring a grove near the base, and then glue a thick round rubber band at the base...

    ...I have a cheap pipe cutter which I'm guessing won't have the strength to cut, but it might be able to score.

  • On my brompton I have a couple of wraps of duck tape around the seatpost so when I pull it up it only goes to the height I want it to, works fine to stop it pulling out any further.

About

Avatar for hugo7 @hugo7 started