You are reading a single comment by @mespilus and its replies.
Click here to read the full conversation.
-
Make certain you have these guys bookmarked:
http://www.bisikletgezgini.com/
for most cycle touring needs in Istanbul.
Make certain you have these guys bookmarked:
http://www.bisikletgezgini.com/
for most cycle touring needs in Istanbul.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
mespilus
So I’m looking for some advice with my touring build which I will be taking to Istanbul this Summer. My last ride got stolen so, short of money, I decided to build something using spares I had laying around and an old chromoly Raleigh MTB frame I found on eBay.
Photos here:
https://www.icloud.com/sharedalbum/#B02JtdOXmy9eLc
(current build thread: https://www.lfgss.com/conversations/251594)
The Raleigh frame came with some late 80s Rockshox which had a tiny amount of travel compared to modern sus forks (about 5cm) - so I was concerned that conventional rigid fork replacements would be too long and send the original geometry out of whack.
After talking to Thorn though, they dug around in their warehouse and found me a pair of out-of-production Raven touring forks, which we hoped would be neither too long or too short. Initially the ride was fine, but my reach was stretched out (think I may have cut the forks too short), so I put on a much smaller 70mm high-rise stem.
2 months ago I then took it for a short tour through Wessex, Somerset and then Snowdonia, and began getting achilles tendon pain early on. I rode through this, until I got to Snowdonia and did my first mountain where it became unbearable. I was then out of action for a few weeks and have been taking it easy since.
The obvious cause of this was having my saddle very high up, which causes you to stretch out your tendons and paddle / tiptoe as you ride. But I’m also worried that the geometry of the bike might be contributing too (it’s one thing to lower the saddle, but to have this happen again in the middle of Romania would be a disaster).
Currently my head tube angle sits at 61 degrees and my seat tube angle at 65 - which as far as I know is very slack, and would cause the bottom bracket to be much further forward from my saddle. It generally feels comfortable, but also I find climbing a little harder than on other rides.
Could the position of bottom bracket to saddle be exacerbating forces on my achilles tendons? Also will it make climbing harder? And what kind of geometry have I created here (ie. is it a monster)?
Any help much appreciated!