You are reading a single comment by @HHC and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@HHC
Again same question however reincarnated:
DIY internal cable routing for the frame, is it a stupid idea or can it be done?
I would simply drill relevant holes into the frame and use a vacuum cleaner at the other end to pick up the cable or something using a magnet. Would the frame be less safe to ride, would its structural integrity be all but ruins? I looked here, where i got the general feeling it can be done though wanted to try the more knowledgable folk on here. If i were to do it i wouldn't be using any braze ons so it would most likely just be a hole, probably at an angle, smoothed around the edges.