You are reading a single comment by @miro_o and its replies. Click here to read the full conversation.
  • was riding the Alan yesterday in the Kent countryside and the nds campag victory crank arm got loose, so had to walk quite a bit up hill and pedal with one leg on the flats and downs, hope the crank arm hole is not worn from the square tapered axle

  • I've had this happen, once with square taper and once with gxp.

    I should probably buy a torque wrench.

  • i've had it a few times on low end shit mate, managed to sort it hopefully today, I used copper grease on the axle, and following the befamed 'tester's advice, tightened crank bolt up as much as i dared, just done about 18 miles on it, so Jah willing, all will be good

About

Avatar for miro_o @miro_o started