For Sale: Slam that stem - low stack headset cover

Do you have 45x2 in stock?

Yes, pm'd

@mdcc_tester I'd like to take one of the 45X2 and give it a go on my Emonda please - il also place a special order for one with a little more depth which il measure in conjunction with the gap left by the 45x2

What's the damage and where do you want me to stick it?

pm'd too

I'm down to my last 45mm cover, so I'm going to have to restock pretty soon. The following people have shown vague interest in customs, I'm looking to have a final cutting list and payments in by the end of the month

Name - Bore - Diameter - Depth
@noiser 28.6|46|3
@dan 31.8|?|?
@miloas 31.8|?|?
@dick 28.6|45|4?

Yay please - il send payment once batch is confined, I might go for 2...

once batch is confined

There is definitely going to be a batch

If you'd like to ship to Norway, sign me up for two to fit the Emonda. I just have to find a digital caliper to measure the depth.

The Emonda depth is 4mm I think from when I measured mine

The Emonda depth is 4mm I think from when I measured mine

In my experience, it's best to measure each installation individually, there's a certain amount of tolerance on the bearing seat depths.

If you want a 4mm deep one for your Emonda, I'll want details and payment by the end of the month.

If you'd like to ship to Norway

I've sent to Norway before.

sweet - will send ca$i$h on Monday

I'm after one for my 585. I believe 46x2 is the size needed. Do you have these in stock? Thanks.

I'm going to make a 46×3 for my 585, as the bearing collet is quite tall. Best thing to do is actually take a measurement, as the height is subject to the vagaries of FSA's running changes in specification. If you pay before the end of the month I can do whatever depth you need, and I have 46×2 in stock if that happens to be the right size for your 585

Bit late replying. But there wont be any spacers. Just my tester top cover, and my tester top cap either side of my stem ;)

When I measured yesterday It was about 1mm between the top of the head tube and the collet. I'll measure it again to confirm size.

Ok measured it and it's just above 1mm, roughly so at most 1.5mm I'd say.

Will the 46x2 be suitable or 46x3?

If it's under 2mm, you need the 46×2 and probably some shims between the collet and the cover.

46x2it is then. How do you want payment sent?

How do you want payment sent?

I've PMed you.

Hi mdcc_tester,

are you still taking custom order?

are you still taking custom order?

Feel free to start a list, but I have a ton of stock in 2mm deep so it's going to be a long time before anything gets made.

I need a spacer with a 52 mm diameter. Do you have any in stock?

I need a spacer with a 52 mm diameter. Do you have any in stock?

No, I only go up to 48mm in stock. I have some left over 54mm bar, so 52mm is possible but if you want it soon it will be expensive and if you want it at the regular price it won't be this year.

I dont want to wait.

Give me your price :p

1 1/8" steerer
52 mm diameter
4mm high.

Thank you!