You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@fizzy.bleach
Very general question, but when you're joining bits of tubing together with butt welds like this (not sure if that's the right term), what's the tolerance in the finish of mitred surface?
Does that make sense? What I'm asking is what's the biggest gap (between tubes) you can fill by welding over it?