ISO Hubs / Bolt on cogs

You are reading a single comment by @noBlakes and its replies. Click here to read the full conversation.

•

allensea

I'd like to convert a 15mm thru axle front hub to a bolt-on 10x120mm rear. Are there any options with off the shelf parts, or getting an axle custom machined about the only option?

I basically just want this but 120mm rather than 135mm

•

noBlakes in reply to @allensea

i vaguely remember phil wood using quite chunky axles, but the chances of them being the same dimensions as your hub, as well as bearing widths is pretty slim. Mack should be able to knock up a decent axle

About

@noBlakes started