You are reading a single comment by @allensea and its replies.
Click here to read the full conversation.
-
i vaguely remember phil wood using quite chunky axles, but the chances of them being the same dimensions as your hub, as well as bearing widths is pretty slim. Mack should be able to knock up a decent axle
-
Are there any options with off the shelf parts, or getting an axle custom machined about the only option?
Never seen an OTP kit, but the custom work is very simple. This one is offset to fit the chainline on my Tandem, but equal spacing each side gives a 41.5mm chainline.
noBlakes
gbj_tester
@allensea
I'd like to convert a 15mm thru axle front hub to a bolt-on 10x120mm rear. Are there any options with off the shelf parts, or getting an axle custom machined about the only option?
I basically just want this but 120mm rather than 135mm