Anyone know where I can buy this? (Cannondale headshok boot - in yellow!)

Like so:

(But the 6 ridge version)

There are a few in black but can't find any yellow ones.
I called up my LBS who called Cannondale who don't have any :(

Anyone seen any in the UK ever?

Thanks!

Paging @Howard, guru of all things Cannondale.

I've never seen one on Qwerty / Doctor Cannondale / Cannondale Experts etc

It's unlikely your shop spoke to cannondale US, more likely CSG in the UK, who then may or may not have spoken to Cannondale US about it...

I wonder if it's possible to dye a black one?

I doubt it. Depending on what it's made of, you might be able to bleach it then dye it, but I can't imagine it would come out well.

I found this but it's out of stock:
http://www.bikewagon.com/cannondale-headshok-boot-kit-6-ridge-yellow

What's it made from? Could you have a replacement 3Dprinted?

Maybe you can find a motorbike fork gaiter to fit.
https://www.google.com/search?q=fork+boot+yellow&safe=off&client=firefox-a&hs=S9C&rls=org.mozilla:en-GB:official&channel=sb&biw=1366&bih=644&source=lnms&tbm=isch&sa=X&ei=H-19VPzxGsS07gaH0oGIAw&ved=0CAcQ_AUoAg

^Yeah cut something down and buy some yellow zip ties. Could be quite a neat bodge, worse case.

I doubt Cannondale make the yellow boots now - that will always read 'out of stock' ;)

Craig Smith might have one / know where you can get one...

Worst case is that it won't fit well, let water / dirt into the roller bearings, and boom your fork is as good as destroyed.

It kinda needs to be pretty much identical to the 'dale original - too big and it will go on OK but it won't seal the internals, too small and you won't get it on without complete dismantling of the fork - which is a horrible job requiring specialist tooling.

I could potentially print one, but I'm not sure how flexible it would be. It needs a flat bit to clamp, so I don't know if a cut down one would fit..

I'm on the hunt as well...in the unlikely event I will find them, do you still need them?